longy509
Member
Hi anyone installed a winch on ironman delux bar any hints or tips would be good do i have to pull the bullbar of to install
Cheers
Cheers
Winch install Ironman Deluxe bar
- Thread starter longy509
- Start date
Help Support Nissan Navara Forum:
longy509
Member
Bump..... anyone....
Scubamurph
Member
Not sure mate. Not familiar with the bar.
Best way to tell is get down under the front of it and look for a removable section
(probably held with 4 bolts) at the bottom middle of the bar. This would be a winch
mounting tray if it is there. It should have 4 bolt holes for the winch as well.
You would need to remove bash plates if fitted to check.
If there is nothing that can be removed then it will be a bar removal to fit winch.
regards Murph
Best way to tell is get down under the front of it and look for a removable section
(probably held with 4 bolts) at the bottom middle of the bar. This would be a winch
mounting tray if it is there. It should have 4 bolt holes for the winch as well.
You would need to remove bash plates if fitted to check.
If there is nothing that can be removed then it will be a bar removal to fit winch.
regards Murph
longy509
Member
cheers scuba there is a removable section just not sure if i will get it back in with the winch on i will just have to pull it out and see.
Scubamurph
Member
I had to use my trolley jack to put it back up into position mate.
A bit too heavy otherwise. A second pair of hands will also make
things much easier.
Regards Murph
A bit too heavy otherwise. A second pair of hands will also make
things much easier.
Regards Murph
longy509
Member
Thanks for the replys
i found out i dont need to take the bar of its a tight fit but it fits
im about to put it on for the 3rd time
1st time i put it in then realised i cant get in to hook the cables up and the engage/freespool lever had to be rotated.
2nd time got it in and had all my cables faceing the wrong way so wouldnt reach control box
3rd time lucky
i found out i dont need to take the bar of its a tight fit but it fits
im about to put it on for the 3rd time
1st time i put it in then realised i cant get in to hook the cables up and the engage/freespool lever had to be rotated.
2nd time got it in and had all my cables faceing the wrong way so wouldnt reach control box
3rd time lucky
longy509
Member
heres a pic of the bullbar not that u can see the winch
trevor1985
Member
- Joined
- Jul 17, 2011
- Messages
- 148
- Reaction score
- 1
were did you get there bar from and how long the waight because they told me 8 weeks.
longy509
Member
pic didnt work have a look in my garage its in there.
i got mine from the local auto one in bathurst.
i got mine from the local auto one in bathurst.
