Hey guys, I'm fitting a set of Narva Ultima 175 Blue's and I'm wondering if anyone knows the best place to pick up the hi beam feed to run to the relay. I can't find the wire in the loom from the hi beam switch, not that I know which colour I'm looking for anyway. But I could easily cut into the wire that goes to the hi beam lamp. Is this OK to use to switch the spotty relay? I was gonna use a piggy back crimp connector to split the wire 3 ways, seems kinda dodgy to me though and I thought there might be a better way. If anyone can point me in the right direction I'd appreciate it. Thanks!
Installing Spotties
- Thread starter Jamesy
- Start date
Help Support Nissan Navara Forum:
D
Dave
Guest
Mate pick up the wire from the back of the headlight. Soldering and heat shrink will last longer then the clips. A test light is the best for it, they only a couple of bucks from a auto store.
Good luck, being a narva kit. It should come with a loom made up already.
Dave.
Good luck, being a narva kit. It should come with a loom made up already.
Dave.
Aussie Frontier
Member
Like dave said
I picked mine up from behind the passenger headlight and ran that to relays
I picked mine up from behind the passenger headlight and ran that to relays
