help! bearing

Nissan Navara Forum

Help Support Nissan Navara Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

SPALDING

Member
Joined
Jun 1, 2014
Messages
34
Reaction score
0
Location
sydney
I am changing my wheel bearing but the circlip that goes on just before you put the hub back on wont go on.It misses out by a mil and i cant push anything back any further to get it on,so now its sitting in the rain completely apart.
 
Push the CV in from the inner side it has a bit of play in the axial direction. Should be just enough to get your circlip back on. It pushes back sometime when it is freed up like doing wheel bearings
 
Worked out what it was,silver o ring that goes on the grease seal came off broke and was stopping everything moving to where it should be.
 

Latest posts

Back
Top