Bvandermaat
Member
Hi all, Just thought I would start a build/help me Thread for installing a turbo on a QD32. I would like to get some photos of the oil feed and return spots on the block if anyone has done this and kept pictures.
From what I can find on the "Denco Kit Fitting Instructions" there are already two hole that just need fittings attached. Now it is just a matter of finding them and figuring out what connectors I need to get.
I will keep a photo journal of my progress and post it up here.
From what I can find on the "Denco Kit Fitting Instructions" there are already two hole that just need fittings attached. Now it is just a matter of finding them and figuring out what connectors I need to get.
Remove oil plug from side of block on LHS in front of oil filter and
regulator assembly using 5mm Allen key. Remove larger plug just
below alternator on side of block to facilitate oil return.
Screw the 3/8 male hose tail into the large oil return hole in the block.
This thread is to be sealed with Loctite Hydraulic Sealant 569. Again
using Loctite 569 screw the small oil feed nipple into the 1/8 BSP hole
in the cylinder block.
I will keep a photo journal of my progress and post it up here.