Been a while
Member
Howdy, i brought a sheet of this adhesive heat sheild to line a side cover on an old honda i restored and thought i would neatly wrap and re-rout the loom from the chip etc..
The loom that goes from the manifold to the pump uses the same stuff ...
I used it on the fire wall behind the dump pimp also, holds up well but you have to seal the edge of the cut materual to stop it from fraying .. heat rated silcone dies the job..
I can upload photos atm?? Sorry, I'll try latter..
The loom that goes from the manifold to the pump uses the same stuff ...
I used it on the fire wall behind the dump pimp also, holds up well but you have to seal the edge of the cut materual to stop it from fraying .. heat rated silcone dies the job..
I can upload photos atm?? Sorry, I'll try latter..