P0546 Error code /Exhaust Gas Temperature (EGT) Sensor Circuit High B1S1

Nissan Navara Forum

Help Support Nissan Navara Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Wramberg

Member
Joined
Jul 10, 2017
Messages
3
Reaction score
0
Location
Sweden
Hi I am a new member, can someone help me with the location of the Exhaust Gas Temperature is located ? I have already spend to much money on imbecile swedish Nissan mechanics that can't locate my idle problem when the motor is cold, so now I'm going to try to fix it my self :( :)

Best regards Nissan Navara 2.5 diesel 2010 automatic
 
Welcome to the forum.

My manual doesn't even have 0546 code in it. My car (2009 D40 STX) doesn't have an EGT sensor. It has a pressure sensor before and after the DPF, but no temperature monitoring.

That means that either:

1) Your car has a factory-supplied EGT sensor specifically included in your vehicle because of your country's emission control regulations, or

2) Your ECU has erroneously issued this error code, which is usually the result of a difficult start (ro a completely flat battery) or a poor connection between battery and its cables, or ECU and its earth, or battery negative cable and engine block.

Checking the last one is obviously easier, quicker and cheaper.

If it's the first one, you may have to take it to a dealer, who will have your country-specific instructions on the fault. Unfortunately they WILL fix it BUT they will do it in order of the steps in their manual, so it could get expensive, but talking to the mechanic there (or seeing if you can swipe a copy of their manual, which comes on a DVD as a series of interlinked PDF files) would help.
 
Thank old Tony, I belive it's a aftermarket product here in Sweden, I will check the ground and after that change the sensor.
Only thing I know is that the EGT should be near the turbo exhaust, if I can find it I can put a resistance of 2.2 ohm and probably the fault will disappear.
 
Back
Top