PDA

View Full Version : Fitting sensors


RLI
07-05-2011, 09:17 AM
G,day gents,

Just enquiring the best place to install oil temp, water temp and boost sensors to vehicle.

1. I note oil temp switch is on drivers side next to oil cooler, is there an
easier location than that?

2. Do you have to plumb the water temp sensor into the radaitor hoses?

3. Can you install boost sensor into ally pipe before inlet manifold?

4. Which is the best location to feed the sensors through, especially given
the size of the water temp sensor.

Does anyone have any photos of their instalations as a referance or guide?

Regards,

RLI