Recent content by dattorob

It doesn't use the OBD2 protocol. So a normal, off the shelf OBD2 reader won't work. For the Consult data, this works (courtesy of fritz.fx member): www.buyobd.com 1 x Nisbie Bluetooth Adaptor A3 (ON-A3) = AU$4.90 1 x Nisbie Bluetooth BT3V24BA with 6-pin (ON-BT3V24BA) = AU$39.86 And the...

It doesn't use the OBD2 protocol. So a normal, off the shelf OBD2 reader won't work. For the Consult data, this works (courtesy of fritz.fx member): www.buyobd.com 1 x Nisbie Bluetooth Adaptor A3 (ON-A3) = AU$4.90 1 x Nisbie Bluetooth BT3V24BA with 6-pin (ON-BT3V24BA) = AU$39.86 And the...

thank you :D

Mate i'm trying to locate this hose on my ute and replace it to avoid in nasty surprises in the future. Can you please circle it in the first picture or provide some dimensions. I had a good look yesterday and sort of scratching my head as to which one it is?

post a short video with sound

maybe an air leak in the fuel ines, does the primer go hard without too many pumps

there is no MAF sensor on the navara zd30 engine. its MAP only.

417k Km on mine, still original injector fuel pump. Intercooler definitely helps or allows unlocks power especially when a part of other modifications.

might be able to use this link, change to your VIN https://www.ilcats.ru/nissan/?VinAction=Choose&function=getGroups&vin=JN1CNUD22A0040381&market=AR&model=D22&modification=1&language=en

re: air flow , yeh i swiss cheesed that area and mounted my number plate lower to improve air flow, but i don't have to contend with winch, i just carry a hand winch.

likely a short circuit in the reverse light circuit which will draw excess current which is exactly what the fuse protects against. Basically its just a process of elimination. Direct Current (DC) electricity is quite straight forward to work with. this video will give you an idea on how to...

Likely because you ran it too low and it drew some air in, did you crack open the injector pipes at the injector, you need to see fuel squirting out there when you crank the engine over. Also you need to make sure its all primed properly before you try to start, if its not then you end up with...

not sure mate , that's a later model , surely someone on here will know , maybe post in a new thread

yeh it is because you can get to it from inside the cab, easier to from memory.

its Taiwan, shouldn't matter? i received mine