Recent content by Gcg7861

Cheers !

I was thinking that also, if the face is extended down it adds a base and extra support. Ill see how I go behind the seat and if its not a goer I'll maybe mockup a marine ply box to do just that and see the result. Alternatively I even thought of reinforcing a timber box with flat bar somehow -...

Legends !! Thanks for that. I knew there had to be at least 1 other option I wasn't thinking of. I'll look into this. Happy John, how have you fixed it down or do the seats and it's own weight pretty much keep it in place? Cheers

Hi All Looking for some dual battery location innovation as I've deliberated over this a fair bit and can't make up my mind. I don't want to spend big bucks on a mount and where I could make my own from ply would be ideal (I have no aluminium or steel welding experience) - For reference I have...

Cheers HJ, yes I was thinking around that area. Blue Lagoon was booked out hence I tried the north east camping zone hopefully I can get a site that is close to the Blue Lagoon main camp area. Also that was my worry regarding the western side: I had 2 options either contend with wind on the east...

G'day Fellas Just wanting some advice on where to camp on Moreton Island. Heading up towards end of the year, and cannot figure out where to camp. Currently booked for North East camping zone however I'm wondering whether I should change this or not? We will be completely self sufficient and...

Probably resolved but I had an EGT sensor issue that kept putting the ute in limp mode. Figured this out with mechanic by first reseting all fault codes, then going for a spirited drive to trip limp mode again and then re hooking the computer to the ute while it was in limp mode and running...

Im running 275/65/17 Federal AT 115T - definitely not a stock size I got them for $150 each and they lasted 53,000 with rotation probably good for another 20,000 before replacement. Not the best if you compare to BFG or MT, but a cheap alternative and definitetly better than stock. Have used...

Through research online I believe they will fit with a 2 inch lift. I am also looking at that size for my next set of tyres. I have a 2013 ST with 17s and apparently they will fit with no lift, so a 2 inch should be fine.

Just as an FYI - I also purchased Aironboard ebay rated points linked above without the rear hitch for like 70 something. Straight install - bolts provided went on perfectlty and I did not need to use the wired nuts in the package. Only change was I had to remove the front centre plastic bit...

So I have two rattles, one of which may be the same as yours. Its on a 2013 D40. At 110kmh I get a high pitch rattle, and this is actually the lock cylinder to the glove box. As you are driving and the rattle starts, push the cylinder in. On my D40 I havent been able to stop it permanently but...

Awesome thanks for the heads up. Im not very handy with a welder but im sure if I measure it up I can get it made inexpensivley or even ask a mate. Have you had any issues mounting on the tub edge and also with a tent or heavy load?

Federal Couragia (All Terrain) Type of tyre - Brand Federal Couragia (All Terrain) Size 275 - 75 - 17 likes & dis-likes Likes: - They were super cheap, I was strapped for cash at the time and found these at $165 a pop fitted - I believe they are on eBay for $150 - Good mileage for...

Hey All Is anybody aware of a rack system styled like the following that can be installed above the D40 tub. I have linked 2 below, that are priced $1,600 + install + delivery, but they are out of my budget. I'm looking at $700 - $900 MAX. My intention is to utilise this as a roof top tent...