Recent content by jscottnjs

Hi all, I have recently bought an aluminium tray, however it is from a hilux. Is there much difference in the mounting points? Or is it easier to buy an adjustable mounting kit?

Hi, I am looking to install a tray and remove the current tub and canopy. Do I need to find a d40 tray or will any make tray fit if I have the right mounting bolts?

Since I have had the car I have had the car bought back to its base tune from standard. But the previous owner has said he had the code before any work was done to the car. However it does say that a blanking plate was installed, when I last chexked there wa nothing there. Like the title says I...

Ah I see, I have attached the work they did just prior to me buying the vehicle. Maybe the cat could be the issue

Its a diesel and that is the only sensor, apart from my own egt sensor I connected with a gauge to see what is going on. Last time the code went off the egt was only 220c

Hi Tony, the exhaust is in good condition, however the reciept I have for tge exhaust states it has a cat delete.

Hi everyone, so I bought a multimeter (auto ranging) disconnected the egt sensor but left it screwed into the car. Continuity testing gave me no readings only open circuit and resistance testing was 71.2k and 136.7 (it was hard to keep the probes on) big question does this mean anything? has the...

Thank you all for your suggestions, I am off to buy a multimeter and also continuing to try remove this sensor. Of course these are placed in the worse places!!!

Ah ok, mine is a non dpf model

I have not got it out yet thjs is the new sensor, well avout6 months old. Do you think I should swap the location of the sensor to where the egt probe for my gauge is? It would move the sensor about 8 inches away from the current location

So this is what I found on the sensor wiring, looks like the heat sheild has been nicked. Perhapps the wire has also been nicked or the heat is getting to the wire and causing a high egt code

Thank you I will take a look tonight

Thank you, it is not a DPF model, I think I will be having a look at the wiring. Is there a tool I can use to assist?

The EGT sensor it's self, I have seen this page but really hoping I do not have to start chasing wiring around the car.