Cheers Bods.
I'll give Autobarn and Supercheap here a shot.
It's basically to give the tray a decent touch up.
Would I require a basecoat to start with or a clear over the final coat?
Oh and I fixed fan on the Navara mate, new resistor.
The cold/hot part almost sorted. It appears cable...
Signal Red?
Mars Red?
Burning Red?
I'm trying to organise some touch up paint so that I can tidy up the ute tray.
Prefer an aerosol and where in Melbourne would I best get such product??
Many thanks again.
Sh*t good point mate. I'm none too sure but I get what u r saying if its not set to hot then the flap wont permit the water to flow through.
I'll have another crack but thanks Tony.
Message to bods and forum members regarding my non operative heater in my D22 2000 model Navara.
I took both hoses off in the engine bay today and tried to run a hose through the pipes. I tried both the top and bottom pipes however the water just kept coming back out whichever pipe I held the...
Far out. My bad all.
**runs and hides in corner**
:sorry3:
VG30E she is......apologies to those who corrected me.
Might take the rest of the day off work......:deadhorse2:
Mate that's a huge call telling me I'm wrong when I've been driving the same car since 2000 I reckon I'd know it she was turbo or not.
Mine is a 2000 Nissan Navara DX, 2000 mode with the ZD30 engine.
The engine is the 3.0 litre petrol/injected.
Not diesel, not turbo.
I'm in Australia by the way.
Any links to references to where to clean the EGR etc and how to block off?
Also note mine is the non turbo version, ZD30, 3.0 litre.
Thanks in advance.
2000 Nissan Navara D22, 3.0 litre.
228,000 k's.
Had one timing chain done at 100,000 or thereabouts.
Does anyone think I should make it a priority to get the next one done or t they generally ok?
Seen some try to attempt it themselves.
No way known here.
Bods I'll give it a try mate but u could be on the money.
I think its moving a tad too freely. Disconnected perhaps???
And is there a troubleshoot link on how to fix it.
Thanks in advance.
As per my subject heading, my heater, whilst the fan is only working on one speed (heater blower resistor), it is only blowing cold air.
It has failed to blow warm/hot air for sometime now.
I have checked both inlet and outlet hoses leading into the heater and both are warm at optimal engine...