Search results

Yes I ended up solving mine. After half stuffing up the clips when opening the central locking mechanism, I found the problem to be with the cable between the external handle and the mech unit. The sleaving on the wire snapped from where it was secured on the external handle. This caused the...

As i have a manual too, I had the same problem. Found it to be the NPS. In tested it by putting my multi meter on ohms/continuity. Test between the two terminals to the NPS. When in gear you should get open circuit (very high to no resistance). When in neutral you should get a closed circuit...

I know this may be a little late, but here was the solution. After all that happened, I assumed the clutch needed replacing. When the mechanic took it apart, found that the clutch springs had began falling apart causing it to not fully disengage. It was a solid fly light thru clutch. Upgraded to...

I've got the same problem with my central locking unit. The door won't unlock through the central locking unit, so I use inside handle instead, although it will re-lock through central locking. I noticed the central locking unit is different to standard actuators. These seem to combine the...

Oil level fine. Bled the clutch also. Still got problem. I verified that the withdrawal arm moved as far as possible when clutch pedal fully engaged. I done this by verifying it position after putting a spacer 5mm spacer between operating cylinder and withdrawal arm, but no further movement...

I've got a similar problem. 2007 D40 YD25 TD Spanish build. I believe it has been upgraded to a single solid mass fly wheel on it. It all started when I changed the tyres from original 30inch to 32inch and went on a weekend light 4wding. I began noticing it hard to put into gear mainly when down...

I've got a similar problem. 2007 D40 YD25 TD Spanish build. I believe it has been upgraded to a single solid mass fly wheel on it. It all started when I changed the tyres from original 30inch to 32inch and went on a weekend light 4wding. I began noticing it hard to put into gear mainly when down...