Search results

Nissan Navara Forum

Help Support Nissan Navara Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. CYDEPX44

    Engine/Turbo Knock

    good day guys, dealers here in the phl have service advisories to transfer the mounting of the controller/actuator as it makes a 'dong-dong' sound at idle hitting against the truck body... could this be it? and citing krunchi's post, the rod that controls the vanes on my d40 does go up and down...
  2. CYDEPX44

    Turbo Failure

    lucky thing my dealer decided to replace my turbo unit - out of "goodwill". i kept pestering them for the technical report as to why the turbo got killed, and after initially turning down my warranty, they decided to replace it rather than tell me the tech report results. someone from devil's...
  3. CYDEPX44

    Shit loads of white smoke and lots of oil in turbo piping

    i'd get the lead of old.tony and keep an eye on the oil level. my turbo got effed during driving and a lot (and i mean batmobile smokescreen like) of smoke went out the tailpipe. lucky the oil level sensor works otherwise i'd be looking at an engine rebuild. if you hear a rattling sound during...
  4. CYDEPX44

    d40 brake wear.

    wow that's great! so, how do you stop? mind sharing your secrets?
  5. CYDEPX44

    Turbo Failure

    every dealer mechanic i've talked to says it should be replaced under warranty but nissan sure is taking an agonizingly long time to get it approved!
  6. CYDEPX44

    Turbo Failure

    exhaust spits out white smoke while driving, normal engine temps, egt's, no error codes. after a minute by the roadside assesing the situation i hear a lloud rattle so i immediately turn off the engine. oil lo indicator on, so i just had it flatbed to the dealer... [/IMG] navara d40 with 75,000 km
  7. CYDEPX44

    Bigger brakes

    agreed, the stock brakes are adequate for normal use. in normal use they feel fine but when the temps go up that's where the judders bugger up my steering, tires, etc. also my discs got resurfaced at 25,000 km. new pads went in with the resurfaced rotors and now again at 70,000 km i've managed...
  8. CYDEPX44

    Bigger brakes

    great news! i hope you can put in a word for us with thai built navaras. as spain built nav rotors don't fit the same, maybe they can do development simultaneously. i've been in touch with winton of dba, and it seems they are still a few months off. i was about to settle for stock sized discs...
  9. CYDEPX44

    Rear discs in a D40

    how would you know if it's either one? i'd like to slip in an LSD with mine.
  10. CYDEPX44

    Engine Loosing Power

    just thought i'd update you mates, i finally got the nerve to tell nissan about my "problem"... it turns out that too much dust in the air filter was choking the turbo into sucking its own rubber inlet tube on hard boost. what a relief!
  11. CYDEPX44

    How many km's on your D40 ?

    D40 4x2 august '08. 24,000 km. in the phils. we only have 4x4 and 4x2. no other trim packages in between
  12. CYDEPX44

    Engine Loosing Power

    nope. all stock except for grippier continental tyres. could there be a lo- power safety mode in the programming that prevents overheating? i seem to hear the turbo un-spool @ 3,200 rpm
  13. CYDEPX44

    Engine Loosing Power

    btw my navs 4x2 and i'm up here in the philippines. everyday i travel 80 km on this perfect asphalt 4 lane tollway. at 100 kmh the revs are just a tad over 2000 rpm. at 140 km, around 3000 rpm. it gets boring after a while and the navs got so much power i can bet you it can outrun an 08 ford...
  14. CYDEPX44

    Engine Loosing Power

    i've a problem with my d40 2.5 crd with 23,000 km. just before its 20k pms i sort of over-revved on 1st gear and shortly after i felt the engine loose power at 2,500 rpm upwards. dealer fixed it but can't explain how and what caused it. now it's back at 3,000 rpm but it only happens after...
  15. CYDEPX44

    What warranty work has your D40 had done.

    both inner rods (they connect the tie rods to the rack & pinion unit) replaced at 23,000 km. they started to rattle at around 15,000 km
  16. CYDEPX44

    Philippines D40 YD25

    good day to all in the forum. i hope to be able to exchange ideas,tech,as well as some gossip related to our special trucks.
Back
Top