Search results

let me knw how u go

hey, it is prob the tensioner not alt .. i just did my alt bearings part no. are in PFI brand bearings B10-50TT thats the 1 in rear and front is 6303-2RS C3 . and u do need a special tool 2 remove the pulley , if u pull the plastic cap of front of pulley u will see. other than that yeh its...

thanx guys, 1 more question where do i get all the piping from to do this myself , as i only have the cooler at moment. hopeing to hav it fitted b4 i head of to frasier island again in sept

hi has any 1 fitted a 600x 300 x 75mm with 3 inch dia outlet and inlet ,, will it fit and how easy will it be to do..

mate, knock it out 1 of best mods goes like a shot cat and lowers the egt temp big difference highly recomend

300 and stil goin strong.. just drive it like u stole it

yeh i hav blanked the egr and done all the vac hoses.. and no i dont have chip in it.

thanks, yeh it is limp mode ,just thought id let ya's know that ecu light comes on first then boost drops to ab out 8psi and its just gutless . will take to some to get tested and post up what senor it was thats fucked,,

thank.s will but no its not that small dia hose running from manifold to boost senor,any more ideas

help.. i have zd30 when driving the engine light came on and then lost power and lost half my normal boost pressure . come on guys im sure some 1 has had this problem , what is it and whats the fix for it

thanks, i measured outside back wheel to out side of other and i got 1860mm

i have a 04 navara just picked up a obeico steel tray but it is 1800 wide by 2300long what is the norm size for these dual cabs so i can cut this 1 down. thanks

go 4 the 3.olt 1 mine is 04 model but try and get the later model 3lt cause they lengthened the chassis and tub by 100mm . wen u get it just service it every 8000kms fit a catch can do egr and and drive it like a company car , mine stll going strong with 278000kms on it

ive run rancho 9000 on a crusier and my mate ran tough dog ralfs on his they were far better go tough dog

com on surley some1 has done there bearings themself . the patrol and crusiers r easy dave cause they r a full floating axle,

tried that but cant find any think on rear wheel bearings... got any other sugestions

wish i could get 700 2 a tank .. getting 9.5km to a litre and 7.7 when i tow trailer. running 245/75/16 wranglers and if u ask me that is very poor.

hi guys , tried doing rear axle bearings 2 day .. took rear shoes off and removed the whole axle with bacing plate then removed the locking nut and plates holding bearing in and the only way i can c the axle coming out 2 get the bearings out is 2 hit the axle shaft up the spline end 2 push the...

mate do not fit them, i fitted 245 75 16 and regret it now its a slug