Search results

Or better still does anyone bring these parts into Australia and sell them from here?

The parts look pretty good and would make it super easy if a suitable front axle could be found. Anyone bought stuff from them before and had it send over here?

Anyone on here done the solid axle swap on a d21? I am pretty sure I have read about one done on a Pathfinder somewhere is Australia and have seen a few done in the States. I read somewhere about using early Patrol front diff and leaf springs, however from what I have seen the diff centre is on...

making progress now, loosened the gearbox bolts and tried to start the motor and it started first kick. When i tighten it up again it gets really noisy from within the clutch. When the clutch is pushed in the noise goes away and when released it gets really noisy, so i assume something in not...

The gearbox turned over smoothly before it was put into the car, I changed the front seal in the gearbox and bellhousing was chagned over. I was wondering if it wasnt lined up properly when the gearbox was bolted in if it may have forced the clutch against the flywheel, cause when it was bolted...

Out of gear clutch out really easy to push In gear clutch in really hard to push I am guessing I have stuffed something up. When I try to start the car out of gear or with the clutch in as mentioned it turns over extremely slowly but doesnt move at all. If i start it in gear with the clutch...

Now got a new problem, finished bolting everything together, went to strart it and motor wound over real slowly then flat battery. Put a new battery in and motor turns over but is doing so really slowly and sounds like its under alot of stain. I assume I have not installed something properly or...

Box is in just need to put it all back together now (torsion bars, tail shaft exhaust, etc). What grade of gearbox oil should I run in it (I assume the gearbox has a few K's on it so I am thinking a little thicker might help quiet things down a bit)?

Got a box today from 86 model petrol, both bellhousings have different numbers on them but the gearbox has the same number as my diesel gearbox. Removed the petrol bellhousing and swapped my diesel one onto it which bolted up perfectly. Gears and syncros all look heaps better than my box so...

Thanks for your help mate, I am in Queensland so although it tempting its a bit of a long drive lol. So would my best bet be to unbolt my bellhousing and bring it with me when I go and have a look at the couple of gearboxes I have found and If my bellhousing bolts onto the replacement gearbox...

Yes it is a 4x4 2inch lift, mud tyres, extractors all the usual stuff. Started leaking gearbox oil when it was pulled apart to change the seal most of the bearings from the front main input shaft bearing were missing and pretty much all the gears were pretty noisy so its pretty much stuffed. I...

I have a 90 2.7 diesel Navara which has needed a new clutch for a while now. Sent it off to the mechanics and when pulled apart found that the front bearing of the gearbox is in a few pieces and the gearbox is pretty much stuffed. Got a rather scary quote to rebuild it so am now on the lookout...