incognico
Member
So I have a new spigot bushing to fit (with a new clutch kit) and am not familiar with this arrangement.
The bush is too large to press into the end of the crank as-is. The bush is correct (well, I have a couple ordered off the VIN from Nissan since I wasn't sure one came in the clutch kit and they are identical).
Does this outer steel section pull out from the end of the crank? Is that the old bushing I can see behind it?
Thanks for any tips!
--Nick
The bush is too large to press into the end of the crank as-is. The bush is correct (well, I have a couple ordered off the VIN from Nissan since I wasn't sure one came in the clutch kit and they are identical).
Does this outer steel section pull out from the end of the crank? Is that the old bushing I can see behind it?
Thanks for any tips!
--Nick