bash plate

[Navd22yd25cr]

Hey ive resently installed a 2" bodylift and raised my bullbar as well to suit the lift. I cant fit bit of the bashplate from the bullbar and my sump bash plate is dented. Has anyone made a one piece bash plate to start at the bull bar and finish at the transfer case?

Cheers

 

[grasshopper]

No, it would be crazy heavy though... and damn unwieldy.

 

[ben85]

could be done.
probably easiest to make it in 2 or 3 pieces though.

 

[Navd22yd25cr]

Even in three bits but should of been a bit more specific but at with the standard bull bar theres a plate on the bullbar and straight after theres a plate for the sump... Just want to make that bit one piece..

 

[tgunn93]

Is there somewhere I could buy a aftermarket bullbar 2 inch lifting plate instead of drilling the holes 50mm lower

 

[ben85]

Is there somewhere I could buy a aftermarket bullbar 2 inch lifting plate instead of drilling the holes 50mm lower

no. just drill the holes, u only need 4 half inch holes.