Media added by vicszd30

shop deals on amazon
Advertise with us
Shop deals on ebay
Nissan Navara Forum

Help Support Nissan Navara Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
[No title]

[No title]

  • 0
  • 0
I may yet cut and remove the "return" section of rubber that has the holes in it "now that it had some heat in it and has formed it's shape and seal"-

I may yet cut and remove the "return" section of rubber that has the holes in it "now that it had some heat in it and has formed it's shape and seal"-

  • 0
  • 0
I punched holes in the return section of rubber to help soften the vibration in through the bonnet.. With two layers of the 3mm inserted rubber it's a

I punched holes in the return section of rubber to help soften the vibration in through the bonnet.. With two layers of the 3mm inserted rubber it's a

  • 0
  • 0
The bonnet insulation is very fragile when you get away from the edges so I stiffened it up with a few coats of "thinned" "under body protection"..

The bonnet insulation is very fragile when you get away from the edges so I stiffened it up with a few coats of "thinned" "under body protection"..

  • 0
  • 0
old glow plug..

old glow plug..

  • 0
  • 0
Tig'ed onto a 18mm to 12mm spark plug adaptor..

Tig'ed onto a 18mm to 12mm spark plug adaptor..

  • 0
  • 0
Solid Bushes....yeeehaaa

Solid Bushes....yeeehaaa

  • 0
  • 0
Front Diff Lowered Cross Member -Rear.

Front Diff Lowered Cross Member -Rear.

  • 0
  • 0
Fron Diff Lowered Cross Member and solid bushes with molly crush tubes... The molly was laying around Mick's shop.. Blessss him ;)

Fron Diff Lowered Cross Member and solid bushes with molly crush tubes... The molly was laying around Mick's shop.. Blessss him ;)

  • 0
  • 0
Relaced both Upper Bump Stops. It didn't need the one on the U/C/A but I thought I'd make it safe'n'sure for travel..

Relaced both Upper Bump Stops. It didn't need the one on the U/C/A but I thought I'd make it safe'n'sure for travel..

  • 0
  • 0
Ready for the boots:)

Ready for the boots:)

  • 0
  • 0
Pump that shite in and then some..

Pump that shite in and then some..

  • 0
  • 0
The "needle extension" for he grease gun is a must for this job! At the right angle you can get the needle right where the grease needs to go..

The "needle extension" for he grease gun is a must for this job! At the right angle you can get the needle right where the grease needs to go..

  • 0
  • 0
Oh yeahhhh one by one - and over 4 times each....

Oh yeahhhh one by one - and over 4 times each....

  • 0
  • 0
After fully washing cleaning drying of needle bearings here comes this joyous job of one by one ! If you don't know how to pack a bearing dont even co

After fully washing cleaning drying of needle bearings here comes this joyous job of one by one ! If you don't know how to pack a bearing dont even co

  • 0
  • 0
Checking full droop with out the boots on.

Checking full droop with out the boots on.

  • 0
  • 0
Sweet fukc all huh!

Sweet fukc all huh!

  • 0
  • 0
yyyyy this much...

yyyyy this much...

  • 0
  • 0
Under full droop! The Tri Cup and shaft miss byyyyyy

Under full droop! The Tri Cup and shaft miss byyyyyy

  • 0
  • 0
To This! And yes -it was worth it! My C/V's Tri Cups will thank me;)

To This! And yes -it was worth it! My C/V's Tri Cups will thank me;)

  • 0
  • 0
From this...........

From this...........

  • 0
  • 0
The "ratchet strap" is just a temporary but it's blocking the original hole where the winder was.. This lines up with the centre of the rim and now ha

The "ratchet strap" is just a temporary but it's blocking the original hole where the winder was.. This lines up with the centre of the rim and now ha

  • 0
  • 0
Extra support plating for winder mount..

Extra support plating for winder mount..

  • 0
  • 0
Plenty of room for Cables and Lines.

Plenty of room for Cables and Lines.

  • 0
  • 0
Back
Top