brandons1455
I like how you think mate i understand what your saying and will be doing something similar. Ive started mine yesterday its very similar to yours but the whole thing in galve steel will be posting photos here and on a new thread maybe. where did you get your gas struts from mate...
D22 Navara have a smaller hub so sunraysias and other rims that fit the larger hubs like hilux patrol and landcruiser will not locate (fit snug) onto these smaller hubs even if the tyre is perfectly balanced and all the wheel nuts have located the rim in place it will not be as close as the...
Well i stripped my drag link ends apart and checked out what made it loose and noticed the bush was worn out so i decided to go something more bulletproof like the heavy duty needle bearings. A small note only one side has a bush witch lets it spin and the other end is a greasable pivoting ball...
Draglink Upgrade
Ok so i have finished the repairs for the d22 steering and wheel alignment. Repacked both front wheel bearing and turns out one of my locking hub bearings had half its bearings missing and the rest were worn so i got a new hub, disassembled the center drag link replaced worn...
Yea i have noticed a difference and quite like the look of it. hopefully will make a bigger difference with an exhaust chip and tune. Worth the money and effort if you are looking at intercooling. :)
here is the finished product of my navara with the intercooler including all black pipes bonnet cut out and painted scoop installed. also i welded up 2 brackets for the cooler tapped a air sensor into it to run to the factory reader and digital boost gauge. along with all that i installed a...
So i decided to finally install my 12000lbs winch here are a heap of pictures. i decided to rust proof and then jet black paint with some clear coat the bull bar, trim number plate, make a new bash plate out of some 4mm checker plate i had laying around. also i found that the bull bar had a weld...