hi guys, just considering a two inch body lift, any modifications
that i will need to do to accomidate the body lift? also what product i should aim for?
thanks for you time, tim.
i stuffed up about 3 different spanners any still unsucessful
i tried shaving down a flat head thin enough to fit between the 0.0001mm
gap lol of all things the vise grips worked haha
mate, i used a really good quality vise grip belive it or not
i had the exact same problem as i needed to remove it for my clutch
replacement. make sure you use high quality vise grips, i promis you
the nut will not get damaged.
it wont hurt to change them anyhow afterwards.
let me know how...
finally
okay i found why it was still stuck haha
i found a bolt that mounted the bell housing from the engine to
the bell housing!!! for those doing it them selves, there only one bolt on the drivers side not far from the top.
ALSOOOOOOO
do not forget to take the crank angle sensor out before...
hey guys ive bought a single mass flywheel kit for my car
and i thought it would be a good idea to change it myself :\
does anybody know if there are any hints on how to get these gearbox'ss
out because im really having a hard time, everything is stripped off,
all the bell housing bolts are...
hey guys my dual mass flywheel has failed AGAIN and quite im over it i just wanted some opinions on the solid flywheel from excedy anyone had any reports on those? im thinking of buying one this weekend with a heavy duty clutch.
thanks for ur time.
tim.
hey i have 48000kms and the exact same problem with mine the bearings
have collaps so desperatly i found a wrecker that just so happen to have one
so that will get it back on the road......for the time being.
so anyways i found these hubs on uk ebay for 90pounds + postage but still
unsure if...
i bought the manual off ebay doesnt help much with the ignition switch but theres over 1600 pages so good luck to me finding it haha
thanks for your time guys, appreciate it.
hey guys, i have bought a turbo timer but im finding
it hard to identify the d40's wiring, is there a diagram
of the ignition system that anybody has or can make up?
thanks, tim.
hey guys happy easter,
i was wondering if there is a manual hub lock for these nissan d40s,
if there is, please let me know if there is a site or a phone number i can call,
im from melbourne but do not mind calling interstate.
thanks guys!
hey guys yep another warrenty problem with my navara...
my friend went under neath my car to have a good look at it,
and he discovered that my drive shafts are leaking from the seals
ANNNNDDDDD my trasfer case is leaking in two different spots!!!!!!!!!!
im calling nissan on monday and...
i just had the flywheel changed to a new dual mass, and the noise is no
different. ive been told from nissan that it is a known common
problem and they will issue people through the mail once they figure out the problem (under warrenty of course)
they said it could take a couple more months...