Bout to drop $610 delivered on a 3L 3" Turbo back Aluminised mild steel system on eBay. Anyone had any experience with these. Are they same as DEA and others out there? How was the install? How do you rate performance returns? Are there other alternatives? Local exhaust shop wants $900 fitted so...
My major concern is this flimsy looking mounting arrangement. The higher mounting of the winch or more so the load point of the line onto the drum not being in line with the mount points is adding a cantilever load. I guess if plenty of folks are running these bars with winches and no problems...
Thanks bods. So you have only used the standard mounting points but not drilled right through the other wall. Then drilled top to bottom of each rail for the two small tabs that help reinforce it. how do you go winching, had any movement or bending with the winch sitting up higher causing a...
Does anybody have a shot of how their XROX bar attaches to the front chassis rails on a D22.
I've searched the forum and can't find what I'm looking for.
I have bought a second hand bar from a wrecker and had it shipped to me. Looking at the supplied bolts (dodgy and practically stripped coach...
where abouts can I find this hose/pipe. I have a wet floor at the moment, lent the car to a mate and he has had the air con on. I've only had the car 3 months or so now and haven't used the air con, only the heater. any help would be great.
I put a pair in too. not too bad, improved the stock feel and at $180 a pair pretty cheap I say. also wound up the torsion bars to bring it back to level. improved the handling dramaticaly, will need a wheel alignment once the rooted rear springs are replaced very shortly. anyone know where I...
Josh
I recomend grabbing the 225's myself. they are pretty good and where I got them they were a great price at under $300 a pair. where abouts are u located?
EGR is a piece of cake to do. all u need to get hold of is a bit of plate around 2mm thick and if u can use a grinder to cut it to shape...
i'd be happy to be a guinea pig, my front suspension is shagged as well. do I just give them a call or do u have someone I can contact and go straight to the source.
3D EGR Mod Plumbing Drawing
the attached 3D drawings look a little dodgy but are showing stock plumbing and modified plumbing to help clarify what goes where. u need to utilise one of the existing t pieces and potentially use a little bit of new hose/line/tube. hope this helps
any questions...