Kit to allow removal of exhaust side egr pipe (prone to cracking) consists of 2x 5mm stainless steel plates and 3x m10 washers.
Exhaust plate can have an egt thread tapped into it so you can read pre turbo temps basically at the exhaust port of cyl 4 which is much more accurate then dump pipe...
Well mine just blew on the way home so thanks to ebay i now have a forefront billet unit on the way.
My only question is..... is there any way to express post it
Hi rumpig i like where your going with this. I have read a majority of the post seems like a good way to get more power out of the little zd30. If i come across another ecu i might give it a go. Soldering isnt an issue as im an electrician with engineering.
Yes. They need a catch can. There is a sticky here. Once you block the egr and fit a catch can the engine will in theory just last and last. That what I did when I first bought mine. Now im saving for exhaust, intercooler and chip
At a glance it sounds like your powering the lights through the high beam cct. Hence why youblew a 7.5A then the cars 10A fuse. Hard to say without seeing it though.
this is why I do the wiring myself
Hey bud. As soon as money permits id be changing them out to Philips 7w led lamps. They are bright and still have a good beam angle and can be had for about $30 each. It may seem expensive but they are guarenteed to work with every down light transformer. Now you will need to go to an electical...