Recent content by stubbsy351

tell me about it, have been trying to get some parts for my ktm from the states, less than half price but they wont send out side of the USA due to dealership rulings.

a fair few years ago my old xe falcon had a 250xflow in it which i decided to convert to strait gas, so i fitted an xf inlet manifold and throttle body, plumbed the gas tuned it and of i went, a couple of weeks later i was off to melbourne when i ran out of gas. unable to contact any one i...

Hi mate i was running a unifilter on mine but only done about 3000km with it before i sold the car. Seemed like a good thing for the time i had it and seemed to increase throttle response a little aswell.

yeah i think bigger might be the go, although by the time i buy a specific drill bit and tap i might as well go the helicoil? will have to hit up the bolt master man and see what prices he gives me

try eddington engineering in central vic (near bendigo) my old boss had a tray built by them for an AU one tonner

Hey guys my old xe falcon has a stripped thread in the sump, so i am trying to decide on weather to tap a new thread (oversize plug) or helicoil it ? any suggestions? Cheers

Thats piss weak, BURN MOTHERF****R BURN

hopefully it works out, you may be onto something

I quit 2 years ago due to cost and have been much better off for it but if they increase the price to stupid levels then most people will quit and the government will have to find somewhere else to get is money from? just a thought!

Does anyone know of a good diesel mechanic / normal mech thats good with zd30's in the townsville area? am trying to sort out my engine/ coolent probs. Thanks in advance

here it is http://www.navara.asia/main-forum/17-d22-eng-probs.html#post27 hope this helps

yeah mate when in forth gear if you pull the gear stick toward your leg the car will start shuddering/jerking. the problem is with the neutral/gear pos sensor just below the gear stick on the right hand side of the box.

yeah mate that would be the go, a cheapie will do the job. Just T piece it off the boost sensor on the crossover pipe and it should read around 15-16 psi

Good to hear

Hi mate, where are you getting it coated? am wanting to get my motorbike frame done