Recent content by tomski

that is what i got a steel cable tie also my bottom clip plastic broke really pis weak went for a mini not a 4wd still dont like silicone to hard to clean ever time cleaning the filter never liked this filter from 1st time i changed element going to try & make a plate front & rear then 2 long...

dont think so airbox end is under a bit of tension hence the clamps would be ok in the middle of outback to get home Tom

hi just about had it with nissan anything bought this D22 new in 2011 all the crap you have to though & money it was going to be my last vehicle as on pension. the last thing i had problems with flat spot at 2600 - 3000 rpm on hills etc. i was thinking bad fuel any way got home from Newcastle...

make no difference car marker is the one that has to get it fixed no matter what:rambo: Tom

hi thanks happy john that is what i need to find out i know how it works and by the way old tony try one because my mate just had one fitted to his hilux heaps of difference gets rid of some of that lag dont pressing the pedal when the bitch dont like it Tom

hi anybody knows if the Adventure Kings Throttle Control Unit now $86 510 will fit it a D22 2011 STR YD25 ? i mean the D40 basic is same Engine ? the model 510 does all this models is hopeless to email them if you ever get a reply its how was our response ? ha never got one or they never get...

hi thanks i will have a look Tom

hi guys got a d22 2.5 2011 does any body know of a good 4wd / suspension shop ? i live i western Sydney between blacktown to Windsor i need a new torsion bar as i lifted rear 50mm 2" front is 30mm friking crappy Nissan navra this was going to be my last car only done 80K since doing cranking...

hi it has to to maintain decent down travel of about 60mm to be legal vehicle jacked up measure your center of wheel to guard heights adjust torsion bar let your front wheels back down to take the weight. Ideally go for a drive and bounce it round to get them to settle. Re-measure your center...

hi you might be on the money today was raining could hardly heard it later when returning home going slow noise started again i also notices that center height changes every time i check same flat place all the time up or down 5mm so when i can will spay them might spray my own joints while at...

hi thanks but not doing that heard about a few problems indexing want to remain legal with 60 mm drop :shooter: Tom

hi i would like the truth about Torsion bar please ha yes i know a lot on here about screwing them up 2" story: fitted 2" rear springs as Nissan crap components was F.... so next step: Torsion bar screwing them up as high as i legally could with 60mm drop & 10mm or so clearance on the bump...

should be ok got a low profile 6" fan i have the torsion bar screwed up about an inch just need a fan themo switch so ready to fit soon Tom

hi thanks yes i just need to find the average temp so i can see the difference going 4wd soon so i can see what difference it making can only be positive. i dont care about the Catalytic converter same as the egr getting blocked done that at 10k huge difference apparently they cant check diesel...

hi i need help with exhaust on a D22 STR 2011 manual not going to replace my exhaust at this stage (on pension) so what can i do safely ? remove the catalyst converter ? different muffler? whats the story about the dump pipe ? i am also going to fit a fan to the top intercooler because i was...