Search results

Rumpig has nailed the problem exactly. Found bits of blue rubber on the floor and other bits stuck in the hole. Went to Nissan and got a new one for $10.00 Thanks to everyone that responded. Cheers.

Hi all Just got home from work , turned off the car, locked up and came inside when the wife tells me the brake lights are still on in the ute. I went out jumped on and off the brakes, went for a lap around the block, turned the headlights on and off but the stop lamps still stay on. Its now...

Thanks Forefront. A good 20 minutes with WD40 and the old double nut technique eventually screwed them out. I think I'll use them again as its pretty tight for space and if you changed to bolts I dont think you would ever get a spanner back in there to get it out again. cheers

Hi Forefront . I grabbed one of your turbos this week from Ebay and a set of gaskets elsewhed but aI m struggling with the bolt on / bolt off concept. You see my old turbo has studs where yours has female threads. Whats the suggestion. see photo attached?

ZD30 Motor ??

$7900 all up inc new head, new water pump, thermostat & rebuild of diesel injector pump. A few $k more and I could've bought another one same age / km and used it 4 parts. sad , sad, sad.

OK the news just keeps going from bad to worse. With the head pulled off the mechanic identifies that the diesel injector pump has delaminated wiring (may be the cause if initial stopping problems) and it needs to be rebuilt - apparently at a cost of at least $3,000. I'm beginning to think that...

No Dave , No chip. I was thinking of it and after cruising the forum was also thinking about a suspension upgrade as its starting to get a bit sloppy in the corners when wet (tyres still good) however I wont be able to afford any of that now.

Ok thanks guys. I think I will be going with a new head and a rebuild of other bits damaged. The mechanic is suggesting pulling the whole motor out as easier to work on if out of the car and if doing that then he then suggests we look at replacing the water pump, the clutch, the injector pump...

I talked with Nissan and they tell me the zd30 engine part no. they have available is 1010 BC628 - and they indicated that the BC628 stands for a Nissan Patrol part. Can anyone here tell me if this would be interchangeable into the Navara. The guy I spoke to didnt know and his boss was away...

Thanks Rumpig. It might be a little late time wise but it could be an option and it cant hurt to ask for the right price even if a day or two late. I have another mechanic doing a quote tomorrow so might be better placed to chase options after that. thanks heaps.

Tweake - No gas test of coolant that he talked to me about but yes to a pressure test of cooling system which lost some pressure when motor started but they could not find any obvious leaks ..... and then yes to a compression test which he called a "head" test which he said initially tested...

Thanks Dave. Maybe he was suggesting that as its probably quicker and easier to replace the whole motor with a recon rather than stripping head down ?

Ok Gents - a mechanic has had a good look over (took 3 days with the vehicle (and he didn't test the oil like I wanted him to .. or crack the head open to take a look) for him to tell me what Old Tony reckoned was the problem with the head gasket ...or more likely the head itself given its a...

Thanks Tony. The mechanic (at service) said the radiator fluids were looking "gunky" and that is why he dropped the coolant and replaced it all. ....sounds like a crossover with the oil somewhere. The white smoke isnt just on cold start. I have noticed after short runs around town OK - so grab...

Hi all 1 week after tightening the connection to the positive battery terminal and also tightening a couple of the airflow clamps I have not had the engine cutting out whilst driving nor holding idle through the gear changes at around 1100-1200 rpm . Fuel economy is better as well. However I...

Day 1 after clearing off some of the "blue sealer stuff" and file cleaning the connections and then some minor tightening of the battery posts and fuel line connections and a 10 minute idle reset , it all seems to be going Ok for now with no over idle issue or the engine cutting out today at 80...

Thanks Tony. I have never used a pressure sprayer on it but have degreased and hosed off in there. The time before last service the engine bay came back spotless so maybe someone there had the apprentice give it a going over - but really the issue pre-dates that. She's also been up to the...

Thanks for the advice so far. I've cleaned up the battery terminals and tightened all fuel lines. They weren't bad but there was a slightly loose connection where another lead came off the positive terminal. I don't think I have a Unichip - that's an after market trick isn't it ? We have had...

Hi all. I have a 2003 ZD 30 that intermittently decides it wants to stop whilst driving. The problem started 5 years ago and it might happen every 6 months or so, but now is more frequent - like every week. Its been to number of mechanics with no result mainly because it doesn't throw a fault...