Search results

I bought a new return line put it in did the reset and I’m still getting 25lph I did a fuel purge and still

Hi guys, 2008 nissan yd25 diesel I did a service new oil, air filter etc Fuel filter is 10k old Did and injector purge a few months ago And I had the diesel return line that comes out the side of the cylinder head leaking oil so I tightened the nut on it which is not the right one for it and...

R51 pathfinder

Hey guys I have a 2009 r51 navara I lifted 2” with shocks and springs, the front positive camber is off and has made the 2 front tires wear fast they were almost new 1000ks ago and I have changed them already, has anyone put offset bushings on the upper control arms to fix this ? And if so any...

I changed all the boost lines even the one on the boost sensor on the inter cooler with brand new lines and I’m getting full boost At the sensor

Hi i have a 2009 yd25 r51 210ks rebuilt engine I had a problem with the boost solinoid after the rebuild I bought a cheap one and didn’t fix the problem I was still getting low boost I bought a Nissan one and it fixed it I’m getting 15psi normal and 20 at full. car drove good for a while I was...

?

hi i rebuilt my yd25 i didnt have the car before the rebuid so i don't know how it drove i get upto 5 to 10 psi and it cuts out straight away, i bought a new solinoid put that on it didnt help, i changed all the lines still nothing i switched the solinoid lines the vac and the one that...

the d40 ones are thicker

Does anyone know the wiring diagram for a 2009 Spanish I looked everywhere can’t find anything 20 pin connector ?

Are the d22 and the d40 diesel oil coolers the same online they look the same but are sold differently and the d22 ones are cheaper?

Just put back the engine after I rebuilt it its a 2009 yd25 bought it with a cracked head didn’t run, after fixing it had a few problems with boost pressure, fixed that then I noticed oil in the radiator, then there is coolant in the oil as well, I took the hoses off the oil cooler and used air...

it’s just a cheap one but it should I haven’t tried I will tomorrow, but I did notice something, there is a plug next to the fuel pump that’s green and not connected to anything, I looked all over but I can’t see where it goes, there is 2 plugs that go to the fuel pump 2 sensors one on the head...

Yeah I did, no light I do have an obd no codes, no smoke from the tail pipe either which I found weird as well

I have a 2009 pathfinder diesel I just finished rebuilding the engine and put it back in, I have not driven in this car before as I bought it not working, I don’t know if it’s just not knowing the car but it feels a bit slow and struggles a bit uphill, the diesel injectors looked pretty dirty...

just about to put my yd25 back together and I noticed I didn’t check which way the connecting rod goes in before taking the pistons off, anyone know how to know which way they go in ? thanks

Vsk

I have decided to do it properly, I’m getting the new head and having the block bored and honed also I bought a full rebuild kit with it new pistons and rings bearings everything, does anyone have photos of the engine bay left and right all put back together, I usually take photos before I start...

it actually cleaned up allot after a long hone, i measured the bore and it is still in spec 89mm, there is still some pitting from the rust but nothing i can feel with my nail, i have decided to keep the car and use it as a daily driver for now, i have called 3 different machine shops today and...

I’m going to do a good home this is just to see