Search results

Hey guys, Might be buying a cheap ARB canopy tomorrow. Will these fit with an "over lip" style tub liner? Or would i need to remove the liner? Regards

I get the same noise. Might happen when reversing, braking, sharp corner at speed. I cant find it and i also have Calmini UCA's. The noise seems to come for a while, and then go for a a while. It really pisses me off but has been doing it for over a year now with no signs of problems from...

Only problem is the weight. 5mm doesnt sound to thick but it will weigh a shit load..lol. 3mm still weighs a bit as it is. I have taken a couple of big rock hits on the 3mm plate. It does deform a little but it has saved me a lot of money and lasted quite well.

Hey mate. That is for the chassis cross member just below the motor. You slide it in from one side so you can bolt to it. Once slid in, there is a retangular opening in the crossmember where the "plate will set". It slides in from the drivers side towards the passangers side. Bit hard...

Thats massive. Be like daylight..lol good stuff.

Cheers will do. Off to tassie for a week camping/4wding so will give its a good look over this weekend.

Hey mate. Not the UCA bushes. I have calmini ones i installed a few months back also. Will jack it up this weekend and try shaking, moving anything i can again. Is there anyway to check the lower control arm bushes without removal?

So hows the knocking noise? still there? Mine has developed a knock/clunk noise. Mainly turning right and sometimes from braking. Shiting me as i cant find where its coming from. Appears to be the left hand side. Torsion bars look fine and fitted correctly. Pete

I emailed this mob last year with the same question. They said no, they dont make them for the D22. Maybe if they get enough interest they may start though.

Hey mate. Thats with gas. Heaps of good info on youttube and all over the net was the way i learnt the basics.lol Cant really help with getting better welds with your stick welder. Dont know enough about it sorry.

Thanks for the comments guys. Bit hard to eplain what i did with the fuel bracket side but hopefully this sketch will help. Will take some photos tomorrow for yous. I basically used the existing hole that goes right through the chassis (Jap 2006 model). Run a long bolt through this and made...

haha, cheers mate and thanks for the dimensions. Tried to keep the angles and lengths similar to yours. Brackets are a little different, mainly the fuel tank one which i came up with my own design. Measuring yours were a huge help though so thanks again. Pete

Hey mate. Saved quite a bit of money doing it myself. But once you add all the little costs up and the hours to do it, it does still add up. Cant remember now what it all cost me. I mainly did it for a project at home, help my get better with the mig. Glad i did it myself though. Pete

yeh photos really dont show how steep hills are. have fun mate, its a great place. Pete

haha, couldnt be bothered doing it all again so soon. I take my time too much. Thanks mate Cheers. Ive only ever stick welded before. Thought i get into a bit of Mig welding. Lots of research and practise. More and more practise to come. Its good fun though. Nice to make your own stuff...

Hey mate, cheers. The flat is 8 thick and the tube is N.S 32 (od 42.4 x 3.2 Wall)

Last lot, all fitted up

More again

more welds

Notching/welds