Anybody used FULCRUM SUSPENSION?

[Michael10]

Have seen a 2 inch fulcrum lift on ebay for about 1200, anybody used it before? Good quality or rubbish?

 

[BigBrownFred]

Iv used these guys to rebuild my old rx7, coilovers, service was good and they did a pretty good job... but was a few years ago.

 

[samcubus]

If price is an issue try ironman. They are not far off that amount.

 

[BlueMutt]

Iv used these guys to rebuild my old rx7, coilovers, service was good and they did a pretty good job... but was a few years ago.

Same here but for a RX-2 Coupe, they custom fitted some Koni's, welding coil platforms to the rears and re-valved them to suit.

They also built the Bilsteins for the rally car I nav'ed in.

Again, it was a few years ago.

 

[Tappet]

I have. Used Bilstiens all-round, King Springs front and EFS rear. They were good and seemed fairly switched on. However they did recommend and fit a standard duty, raised spring front. Lift was ok but turned out to be to soft for my liking. Ended up fitting HD Dobinsons on the front and all sorted. Still rides great and handles the rough stuff good.