Nissan Pathfinder Ti 550 R51

Nissan Navara Forum

Help Support Nissan Navara Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

spcam72

Member
Joined
Sep 14, 2023
Messages
3
Reaction score
0
Location
WA
Hi

We are having a heap of issues with our pathfinder losing power. We have changed fuel filter, changed sensor, checked timing train... etc. It comes right for a bit and then back to losing power. This is so bloody dangerous and seems to be a common problem with Nissan. Anyone got any other ideas to try? We are looking at taking it to a diesel specialist in WA.
 
There could be a number of reasons for it.

You could have a boost leak - you might notice a different sound when it happens, but you'd certainly notice a drop in boost pressure. A commonly-used tool to monitor this (and a laundry list of other stuff if you want) is Torque for Android. All you need is a ELM327 Bluetooth OBD2 adapter, that app and set it up. Watch the boost levels.

Smoke makes a difference too. If your SCV is faulty, you might not see a lot of smoke, but restart the engine and everything works again. A bottle of injector cleaner might see that right, and I'd particularly do this if you notice that the engine doesn't idle steadily, but surges mildly (we call that "hunting" ). I had this happen to my car while we were in SA recently and a bottle of Nulon diesel injector cleaner did the trick - and I usually use Liqui Moly. It goes to show that brand really doesn't make a huge difference.

If it only resets (improves, goes back to normal, however you want to say it) after turning the car off, that's usually a sign of the SCV too. If it's overboosting (actuator fault, say) you should be able to get it running properly again simply by lifting your foot off the throttle and going again.

Other possibilities: faulty EGR valve (will make it run sluggishly, and produce black smoke). It could be an air path issue (may not produce smoke if the MAFS has figured it out, perhaps dirt inside the filter box?). A failing turbocharger can also do this (expect black smoke). If there's some wobble in the turbocharger's shaft it could "stall" as it spools up. Pop off the hose that runs between the turbo and the intercooler and wipe your finger on the inside then check the oily residue under a bright light. Sparkles = bad turbo.

That's a start, anyway.
 
Thankyou for the reply, we have replaced the SCV and it ran well for 3 weeks and then today did the same thing. We will look at the turbo boost I think. No smoke is being produced, no codes etc. It is so strange. EGR is something to look into as well. Cheers
 
These motors have a common problem with the EGR starting to fail and they will not throw a code until they fully lose power.
The problem is they snap the shaft where the solenoid actuates and will work fine for periods but then completely breaks and that's when you get the code.
I have replaced two of these recently on different motors and it has been the same each time.
 
These motors have a common problem with the EGR starting to fail and they will not throw a code until they fully lose power.
The problem is they snap the shaft where the solenoid actuates and will work fine for periods but then completely breaks and that's when you get the code.
I have replaced two of these recently on different motors and it has been the same each time.
Thankyou, will look into this, appreciate the help
 

Latest posts

Back
Top