Hi all, after replacing my tail lights, I have realised that I have not had reverse lights on my old lights or my new ones. I think I have located the reason for this by crawling under the car and finding a switch that appears to be on the bellhousing area, that has bare terminals and no wires going to it.
My trouble is that I cannot see what would plug into it. Further back in the loom there is a two pin connector that has 12v to it, so is there a small 30cm loom that connects the two?
I should mention that my D21 is a 96 model with a Teranno non intercooled turbo diesel engine and probably a Teranno gearbox as well, is there is any difference?
I need to test to see if the plug I have found is actually for the reverse lights, most likely by bridging the terminals, I will either blow a fuse or my reverse lights will come on!
Does anyone know if I am on the right track?
Anyone else had a similar problem?
My trouble is that I cannot see what would plug into it. Further back in the loom there is a two pin connector that has 12v to it, so is there a small 30cm loom that connects the two?
I should mention that my D21 is a 96 model with a Teranno non intercooled turbo diesel engine and probably a Teranno gearbox as well, is there is any difference?
I need to test to see if the plug I have found is actually for the reverse lights, most likely by bridging the terminals, I will either blow a fuse or my reverse lights will come on!
Does anyone know if I am on the right track?
Anyone else had a similar problem?