Recent content by fudly

wasn't that hard tbh http://www.navara.asia/showthread.php?t=27180&highlight=delay+shutdown talked about it in this thread

auber aswell hooked it up so it holds the ignition on till the temp goes down works well

yeah the gauge is a turbosmart boost gauge and I plan on mounting it on the steering surround behind the wiper controls, just had alook and cant replace the bulb without pulling it completely down

i just purchased a boost gauge and was wondering if I could wire the light power directly to the back of the switch or I would need to put a fuse in??

for the diagram slide 4 dual trigger light bar wiring would it matter if you were connectingit to a 188 watt light bar or would there be upgrades needed??

im about to put in a manual boost controller and was wondering if anyone has tried...

I ended up putting me small forefront one on the motor next to the dipstick seems to work well and got me oil resistant hose from autobarn had to heat the hose to get it to fit over the can

thanks rumpig I looked throu the manual to and they mostly seem to be engine related apart from 0206 which I couldn't find so im guessing I miss read that one. im hopeing there all left over from the engine change so I cleared them and will see what comes back and go from there

You can get the fault codes by bridging the terminals 8 (IGN) and 1 (CHK) of the diagnosis connector located below the lower dash panel on the drivers side. The diagnosis connector has 2 rows of connector points. No.1 is the bottom right one and No. 8 is the bottom left one (could be upside...

after owning my 03 d22 for a few months not I decided to have ago at pulling the codes outta the puter and well I found quite a few 73, 26, 104, 31, 95, 43, 52, 42, 47 I was told when I purchased the d22 it has had a engine change and I was wondering if these codes might be from the old engine...

how you do it just redrilled holes??

http://www.gumtree.com.au/s-ad/kelvin-grove/other-parts-accessories/engine-chip-diesel/1043902943 found this on gumtree if anyone is interested not at the point were I want it yet so ill wait for the next one hehehe oh this is located in brisi area and no it aint me selling so I know nuttin...

same thing no idea ive just been blaming my tyres

snorkel might be usefull and welcome

Can get cheap trays in brisi all the time you would just have to modify it to fit is all