Recent content by Ihaterocks

Just had my car in a Nissan today for what sounds like tappet noise at between 1500-2000rpm. Engine under load, noise is almost non exsistant. I own a 2011 st. So dealer charges me 200 to put injector cleaner in, some sort of inlet clean which is sprayed in inlet to de carbonise and a fuel...

Was up alpine region over Easter and 4wd low fourth gear surged badly between 1500 to 2500rpm. Was that bad I shifted from 3rd to 5 th were I could. Took my dp chip off just to make sure, still happened. I'm booking it in to Nissan this week. Will keep you posted. I have a 2011 ST Thai built...

I run them both in ute tray on a 105 amp hour full river battery. Usually get 2-3 days out of battery without charging. Battery is charged off car and Given a deep cycle charge once a month at home.

Hi. I currently run 2 engel 40 litre fridges. I believe this is a better way of doing it from a power consumption point of view. 40l draws max 2.7 amps per hour. 80l draws 4.2 amps per hour. If you vacuum seal your meat and pre freeze, your freezer will cycle on and off far less. From a...

I've done 65k on mine. I have 265/75/16 on mine. Sucked a little power out of the engine turning the bigger tyre, but speedo is accurate. Nav st 2011. I rotate front to back every 20k. Have another 15k of tread left in tyres. I run 40 towing boat and 36 for everyday stuff. Ran 12psi on Fraser...

I have ARB also. Got it installed by Nissan (ARB)as part of my lease package. The rear rubber seal keeps falling off at various points around edge. I keep gluing in various places around edge. Probably covered by warranty, not annoying me enough to take in. I think it was 2700 installed. If I...

I have just installed a pair of Rallye 4000 spotties and would like to know where the easiest pick up for dash lights would be in order to light up my arb rocker switch. I have the switch fitted beside the mirror adjuster. Any help would be appreciated.

Looks like its going to be exhaust and chip mods in the not to distant future. It was never going to be as simply as an ecu program. Thanks all for the feedback.

Wondering if some one could shed some light on this for me. I know with a chip and exhaust similar figures can be achieved. However, if it is tuning, can the ecu be re-programmed to a achieve the same output? Have tried to search forum for an answer but am struggling a little? Sorry if this...