tommy222220_0
Member
Lift your Nissan/Arb steel bar to match 50mm bodylift
One of the easiest mods to do. (drill 2x12mm holes)
Bolt the mounting brackets up as per normal.
You'll notice there is already a hole (round) 45mm below the std oval mounting hole. (see 3rd pic)
Use this, mock the bullbar up using these 2 holes and adjust the gap to guard clearance so its equal.
mark where new location hole in bullbar goes with scribe. Drill with 12mm bit.
Bolt up and enjoy the newly lift bar
One of the easiest mods to do. (drill 2x12mm holes)
Bolt the mounting brackets up as per normal.
You'll notice there is already a hole (round) 45mm below the std oval mounting hole. (see 3rd pic)
Use this, mock the bullbar up using these 2 holes and adjust the gap to guard clearance so its equal.
mark where new location hole in bullbar goes with scribe. Drill with 12mm bit.
Bolt up and enjoy the newly lift bar
Last edited: