Hey guys new to the page. Chasing some advice. i done a water crossing in my 2007 d40 t/d manual, it drove through it but on the other side it cut out. It started again and now it runs and idles but revs really slow. If i hold accelerator down it revs well over 2 grand just takes forever to get there. My mate put his computer on it and it came up accelerator fault. I have pulled most sensors of that I have been reading about that can get water in them and sprayed with contact cleaner and my old man has the same nav so I have swapped over the following
Throttle
Throttle body
Fuel rail pressure sensor
Air flow sensor
And still no go. Any help would be appreciated. Thanks
Throttle
Throttle body
Fuel rail pressure sensor
Air flow sensor
And still no go. Any help would be appreciated. Thanks