Hi
Just wondering if anyone has experience same issue,
Installed 4no. 2nd hand injectors in my 2008 YD25 Navara str..
Previous injector numbers started with D2___(+ 28 other digits.)
New injectors D3___(+28 other digits.)
When I try to program the new codes into the ECU it gives me a fault..
Will not except D3 codes..
Engine runs drives fine, just a slight rattle when not under load so though updating these codes would help.. Using Delphi software version 3..
Any help with this would be much appreciated..
Just wondering if anyone has experience same issue,
Installed 4no. 2nd hand injectors in my 2008 YD25 Navara str..
Previous injector numbers started with D2___(+ 28 other digits.)
New injectors D3___(+28 other digits.)
When I try to program the new codes into the ECU it gives me a fault..
Will not except D3 codes..
Engine runs drives fine, just a slight rattle when not under load so though updating these codes would help.. Using Delphi software version 3..
Any help with this would be much appreciated..