Need measurements for tray mounts

[AndrewD]

Hi all,

I have bought a tray to go on my D22 dual cab. It came off the current model hilux dual cab and of course has different mounting points to the navara. Can anyone please help me with some measurements I need?
- The height of the tray brackets/ cross members (eg 100mm 'C' section, etc) for the front mount, and the two rear mounts.
- The height from the chassis mounting points to the base of the tray, and
- The height of the front board, from the tray to the top of the roll bar.

Thanks for your help.

 

[scooba_285]

if your planning on doing this yourself theres an easier way which i did, my steel tray also came off a hilux and i had to cut the old mounts off and make new ones

cut the old mounts off and put the tray on the nav
put blocks of wood etc under the tray to get the height you want and get it sitting level and square
then measure the height for the mounts
make the mounts and tack weld them on
take the tray off and weld them on properly
put tray back on and bolt it up

was pretty easy to do, i used 50x50x6 angle and 50x10 flat bar to make the mounts