jap55s
Member
ok, so i have flushed the radiator, changed the hoses, changed the thermostate, the repco one is a diffferent make to the original, but same dimensions.
now this is where i need advice.
i put the new 'O' ring around the thermostat.
then i put the housing back on, and coolant leaks, do i need a new gasket? there was not one when i took it apart? or do i just need to make it tighter? (last time i went too tight i snapped the bolt).
or do i just paint on a little bit of locktite as a gasket?
thankyou.
now this is where i need advice.
i put the new 'O' ring around the thermostat.
then i put the housing back on, and coolant leaks, do i need a new gasket? there was not one when i took it apart? or do i just need to make it tighter? (last time i went too tight i snapped the bolt).
or do i just paint on a little bit of locktite as a gasket?
thankyou.