K
krawczuk
Guest
hi, i got the big 41mm nut of the zd 30 crank , but the balancer hasent got any holes etc in it to bolt a puller into.
how do you get the balancer of ?
mark k
how do you get the balancer of ?
mark k
Help Support Nissan Navara Forum:
seventies47
Member
Trya nd find a specific puller that 'grips' the drive belt grooves on the pulley.
Sorry man I dont have a ZD30 manual ... you may need the claw type
I know this is a bummadore, but you get it.
I would discard the balancer though if you had to use this method its unlikely to be useful and could be damaged.
I know this is a bummadore, but you get it.
I would discard the balancer though if you had to use this method its unlikely to be useful and could be damaged.
K
krawczuk
Guest
Sorry man I dont have a ZD30 manual ... you may need the claw type
I know this is a bummadore, but you get it.
I would discard the balancer though if you had to use this method its unlikely to be useful and could be damaged.
hi, it was a little hard to use that type of puller. cause the back of the balancer is chamfered.
what i done was get a hammer and tapped from behind a little, turned crank over, tapped again , took a while and it came off. !!! yay !!
mk
