I to am interested in this.
My d40 does the same thing only every time I get a chance to look at it (I'm an auto election with my ac tickets) it doesn't do it.
I have degassed the system and pulled the fittings on the compressor off to inspect inside for any evidence of an internal fault but...
Hey mate it is really easy..
pop the small panel off on the top of the dash above the radio.. The one where you can sit your keys or phone etc.
Then remove the 2 screws inder that cover that hold the surround on. Hen carefully pull the surround off. It may be tight but it is only held on with...
Mate if it locks with the lock all button then. It will have an actuator.
Can you unlock it with the same button?
Other wise does it unlock if you unlock the lhf door?
Oh and doesn't have to be a vision central lock kit. I have used from supercheap brand one through to expensive ones and they...
Hey mate it depends on a few things.
1: what vision alarm model you have ( can be done with all of them from memory but some require a central lock module as well where others have the ability to do it all in the one)
2: whether you drivers door has a central lock motor.
If it is the vision...
Hey mate check if you have hazard lights.
Also check the hazard light fuse as well.
And when you check them are you just pulling them and eyeballing them or are you testing to see if there is 12v at them?
hey mate.
the iron man front struts comne with a 10mm spacer that can be fitted to the bottom of the spring base plate. they are gold on colour from memory and sit at the bottom side of the spring.
i woiuld check to see if your strut assemblies already have them in place. and if not i would...
All good points..
First off, this is what I do for a living. Some cars switch negative and some positive. So if you wire it like this then no matter what way it switches it works. It is a lot simpler then you think as there is a lot less time running tying to figure out what switching a car...
Hey mate hear is a wiring diagram that I made to help people wire them up themselves.
This is how I always wire cars with a h4 globe as it will work with either + or - switching.
Hey mate..
I have just purchased an arb bullbar and the guys at arb said that the wiring is already in behind the factory bar and all you have to do is plug the lights in and buy a new head light switch that also incorporates the fog lamp switch
Part number is. 25540-ec40b
I should get my...