Recent content by Blackhander92

Shweeet!

For this dawes valve, a pressure supply is needed to unseat the ball in the valve. On the Patrols it seems that people are just drilling into the pipe that goes to your intercooler. As I don't really fancy drilling any holes, my question is, could I just run a tee piece and a bit of extra vacuum...

Has anyone actually installed one of these on their navara just out of curiosity????

Here's hoping!

Sounds good to me, I think ill just run the single dawes valve setup with a needle valve which I will also probably just keep in the engine bay as I cant see myself tampering with it too much once I have it at a desired setting. Cheers Camo.B

Also check all your fuel lines for any little cracks around the ends. You may have air getting into the system somewhere

You have definitely bled the fuel system after replacing the fuel filter? I had this issue a couple of weeks ago after replacing mine. Just gave the system a good air bleed and she has been right as rain ever since.

Getting real tired now of this fault finding haha. Couldn't manage to get a hold of an ECU nor an oscilloscope. I jumped the wire going from the ECU to the Solenoid using a scotch clamp and still no luck. So I think I'm going to cut my losses and just attempt to install the manual boost...

The filter brand I have is a ryco.

G'day guys, Quick question, I've replaced the fuel filter assembly in my 2.5l 08 Navara and air bled/primed the system and car starts all well and good.... However, if I leave it for over say 6 hours without starting the car, I have to air bleed/prime the system again and the car again starts...

Id imagine closed yeah haha

http://www.dtcsearch.com/P0045/?from=Torque Got this today. Circuit A, is that the route from the ECM to the Turbo Boost Control Solenoid? Only got this after doing continuity checks yesterday.

Its just cause it may save me alot of money in the meantime as im looking at an ECU replacement as the solenoid is not getting the right signal to the tc boost control solenoid.

G'day guys, Just a question for everyone out there, has anyone fitted a Dawes valve to a YD25? And if so, how easy is it to do and how successful is it? Installation tips would be handy, plus a place to buy them from. Also, did you require a needle valve also? Ute is a 08 2.5l STX Cheers boys,

Might be able to yeah, just have to see if my mate is willing! I am just a tad hesitant in case the immobiliser trips. Which I really dont want.