So the hose from your airbox to manifold. Take that off then spray down the intake manifold whilst idling a bit higher than normal. I just used the heat switch so 1500rpm was fine
Hey mate. From what i have found the liqui moly intake cleaner is primarily a trade product. You could try asking around some diesel mechanics to see if they use and will sell you a can or otherwise autobarn said they could order them in for me but i would have had to pay for 6 (min order) or...
Mine does the same thing on the drivers side. Feels like its a loose wheel nearly when hitting bigger speed bumps? Ball joints are all good and everything is tight. Same as you installed brand new lovells shocks thinking that was it (and they were gone) but still had the loose feeling. As i...
So autobarn needed to order it in for me and wanted to charge me $29 for a can (no worries) and as they needed to order 6 min, wanted me to pay the postage... and were going to sell the other 5.... needless to say i told them that I wouldn't be funding the postage of their stock.
Spoke to my...
http://m.youtube.com/watch?v=WrpxoxYmPsc
Hey just wondering if anyone has tried this yet?
posted in engine section aswel but wasnt getting replies so maybe wrong spot!
Took my intercooler off today and my intake manifold looked at least this bad if not worse.
What are the implications if the...
Hey just wondering if anyone has tried this yet?
http://m.youtube.com/watch?v=WrpxoxYmPsc
Took my intercooler off today and my intake manifold looked at least this bad if not worse.
What are the implications if the build up that is being dislodged is going through the engine? Someone was...
Just trial it with a whole single turn and remeasure then you know for sure. From what zordo was telling me he aims for 10mm off the top bump stop when installing new gear.
Really easy mate. Like you said measure the guards first to get your base point. Then jack up the front. Loosen off the locking nut at the top then while holding the bottom nut in place tighten (up) or loosen (down) the big bolt underneath. Drop her back down and reverse out then back in and...
Did this today And Works a treat. So much smoother through the rev range. Was running pretty rough before and the fuel additives weren't cutting it. This however was an immediate improvement.
Hey guys/ gals,
Just wondering if anyone knows where I can get my hands on a ball joint press? Im trying to avoid having to buy an expensive one as im hoping not to need one too often.
Wondering if anyone has one I could lend (brissy) or if anyone has tried the $80 odd ones from ebay? And if...