But you wouldnt get the same thing. You would have a set of spacers under your coils. And probably leafs. Wheres the benefit in that? Why wouldnt you just get that Calmini lift if you want it to be as good as a maloo or f6 offroad? If you wanna drive around on the road and look cool. Well then...
Who are you? Seriously. Did i say it was better? I would say its better then OME yes. As for better then the sas. Its two totally different animals. Im happy with mine as far as hieght and flex.
And yea it would probably walk all over mine because its solid axle. No brainer. Im sure
If i went...
Well guys i probably should do an update. As you know ihave the MR kit in the nav. I recently got the adjustable fronts and put them in muself and set them a touch over 3 inch. So far has handled awsome. On and offroad. Good wheel travel and good handling. As for the rear i removed the one inch...
Mate it depends what uou wanna do. Ive got 33s on mine with 3 inch lift. I had to cut my guards. Ive since cut a whole lot to gain extra clearance for the tyres. If you get a 2 inch body, yea theyll probably fit but be useless of road due to flex.
Depends what floats your boat.
Gday mate i noticed your from bathurst. Ive got a bloke from there that can put the kit in for you. Doesnt. Harge much and gets in there and smashes it.
Yea mate no worries. You should of just come and grabbed one of the boys. They were flat out most weekend but happy to help anyone. I will deffinatly be keeping an eye on things to come and letting you guys know if matty doesnt due to being flat out. Hopefully not to far away.
Haha yea i know...
Hey guys. Thinking of getting a new dump for my d40. Its diesel manual and already got a 3 inch from the dump Pipe back. Just wondering if anyone has done this without a cat in it and What its like. As in powerloss, sound, fault codes etc.
Hey guys. Thanks for being so patient with this kit. As most of you will know matty is always flat out and hard to contact. The website is still under construction and should be ready soon. As i hope some of you seen, i was at tuff truck this weekend with the nav and the MR 3 inch kit on. I got...
Hey guys. Im in the process of making some diy draws for my nav. Ive got all the measurements and just about to price some wood. I think im gonna go with 2 draws which measure about 500x1000. Or there abouts. Depending on the slides. Well i was just wondering wheres the best place to get some...
Just went to the local muffler shop and got priced 250 fOr a new dump pipe from the turbo to the original cat? Im guessing they would just weld it on to the original cat and then continues to the humex system. Whats your opinion on this?