Search results

Does anyone have any problems with the dump pipe rubbing the firewall under load? / how close does the dump come to the firewall?

By the looks of it they have used gasket glue and just wedged it between the pipe and the fire wall

So i took it back to the Exhaust place (mettams Mufflers in morley) and they are blaming it on the exhaust rubbing on the heat shield on the firewall i have had a look and there is no clearance at all. Any suggestions? it only happens under load I.E. taking off up hill.

I have MSA fit ok and look good, they have 3 back pack clip on straps and 1 velcro stap on each front seat. I found that they never quite fitted perfectly but good enough, maybe a bit tight around the seat bolster. The bottom section of the back seat was a bit tricky to fit.

Thanks mate i'll have a look

Nah mate its a custom made one with heaps of clearance. I'm thinking that one of the welds has a leak in it so ill take it back when i get time :)

Hey guys i got a 3" exhaust put in about a week ago it sounds great but when under load and acceleration a loud noise comes up from around the front seat area. I have had a look at all the welds and they look ok. Does anyone know what that could mean.

I ended up going with mettams mufflers. 3inch with dump, high flow cat and no muffler $1000 all up with from what I can tell 1 small non mandrel bend at the end. Good service and it sounds great. Well worth it.

Thanks mate ill give it a go

I have 16x8 on 0 offset with 265/75 they scrub bad. I stupidly let Perth 4x4 talk me into the 0 offset. I have cut back the metal in the tyre arch but still scrubs would a extra inch from a UCA help? Or do I need to go more nuts with a grinder and hammer?

I have a AOS swag ( Australian outback suplies) its great!! http://www.aosswags.com/australia/

Cheers mate I'll let you know :p

Hey mate i'm about to start making my own steps what length and width did you go with? I measured up my Nav today and i came up with 1980 L X 210 D

Hey mate this is where I ran the boost hose into the cab it's on the passenger side behind the fuel filter

How hard is it to get past inspection and made road worthy in WA and is it worth the hassle. I would rather keep most of the car legal :-p

Hey mate I just put a T piece in the waste gate line coming off the turbo and ran it through the firewall on passenger side. I will post up photos later today if it would help

Thanks mate did you get a cat? They tried to talk me out of getting one so I'm not sure if they are high flow cats or not

After a bit more research and a lot of phone calls I have narrowed it down to mettam's mufflers (perth)or beaudesert exhaust (qld) they are both about the same price. Has anyone on here used mettam's mufflers? I am looking for a 2.75 - 3" with dump and cat but no muffler!

Hi there, can any one confirm whether the template will work for the newer Thai built d22?