Johnkathy81
Member
Send scottybobcat a pm
He has a heap of custom bash plates
They are improved tjm plates
Stronger and cheaper
Thanks mate, will do!
Send scottybobcat a pm
He has a heap of custom bash plates
They are improved tjm plates
Stronger and cheaper
I did a similar mod on the 2012 ST but i used 2x 8mm flat bar welded to the original angel line crossmember that bolts on in between the chassis rails, same outcome just got there in a different way, BUT it really is a must do IMO.
I also cut the 2 tabs off either side of the bottom tank of the radiator that were meant to locate the original plastic bumper as they have been known to cause problems with other plates and if hit they can snap out leaving a hole in the bottom tank the size of a 50cent coin, so better safe then sorry, just run a hacksaw blade through them and in 2min they are history
Pretty sure my bash plates were around $500 installed.
yeah mate i have the full arb set with stock bar and all good.
pretty sure the tjm don't cover as much as arb.
cheers Gav
http://www.navara.asia/attachment.php?attachmentid=15022&stc=1&d=1397555060
Enter your email address to join: