Looks awesome. Exactly what I want. Have you got pics of the top showing how the canvas sits with the rack?
Also, what's this thing weigh? Two person job to remove it or not?
I was thinking pretty much like this but I hadn't even thought about making it lockable, was going to leave the sides bare canvas. Then for removal/fitting I'd just tilt it off the back and stand it up.
But again, looks awesome.
That bit highter than the cab is so to make the doors a bit higher to stand under and to lift the roof rack a bit higher with aiming on
Also have at look throught case84 old d22 the canopy and rack saved the life on some people beening a bit higher the roof did not move as much
The front and rear hoops were 50mm tube and 4mm thick
A hint make it strong
Funny what u find wen u can't sleep
I did make a lock for the tail gate
Here gose
The tub part
The tie down point in the tub next to the tail gate I put a chain on there and a dog clip on the other end held the chain onto the tub part with a cable tie it only there to stop the chain sliding off
The taile gate
top part of tail gate I put a hook thingy not sure what u call I but the dog clip can't come off it done lock made
Could only open taile gate went back door is open or wen the chain was not on I put one chain on both side
Hope u no what I'm saying
And how much was the canvas Case?? How did you go putting the roof rack on. is there just a hole in the canvas or something else. i know you dont have it anymore but any extra info would be great.
Enter your email address to join: