Hi
I am going to make a set of these for d22 nav.I just want to know did you make them out of flat plate or angle iron
Shane
mgermasi said:Hi mate I have a Navara D40 RX Thai built and I want to make the same recovery point that you have.
Question: to access the recovery point nuts inside the chassis, did you have to remove the bullbar?
Many thanks
The nuts are welded inside the chassis. Now for the $50000 question. Does anyone know what thread they are for a Spainish D40?
Removed the tiedown bracket and it looks like a fine metric thread but not sure which pitch.
Got 2 Rhinomax recovery points off eBay.
Just thought i would post the drawing of the front recovery points that i made due the unfortunate happenings of the outback ideas gentleman not being able to manafacture them,so i hope this drawing helps.
Enter your email address to join: