Recent content by Saitek

A quick question before you go and make something completely custom, how much better does it go without the restrictive piping off it ie have you tried it with just a pod filter on and taking it for a drive? I had a thought about doing something minor to achieve more flow out of the standard...

I buckled one of my ally rims a while back and have since done 5-6k on them(wouldn't recommend if possible) and have just bought a set of second hand ally rims to replace the buckled one and the two steel spares. Point is that they hold together really well.

I think I used a Carter 4600hp and I cut into the steel fuel line under the drivers seat and mounted it on the chassis rail close to the floor and pulled the wires out through the rubber grommet above it. Also chassis has nut serts in this location so you just need to make up a right angled...

I have also heard people say a turbo from a Mitsubishi triton delica is pretty good upgrade but have never seen any evidence of which one fits and what had to be modified for it to fit in my mind it must be some sought of td04 like...

The four wires at the back of the pump not any of the wores in the loom to the pump. Out of the four wires the wire closest to the top of the motor and the drivers side.

The're is 8 load points and a range of delays and such that are changeable with the module that tunes them. And as stated in the original post would definitely recommend the tuning module straight up as they are tuned for patrols not navaras and the tune is pretty aggressive. Might be okay for...

Yes correct I purchased the programmer module as the unit itself is sealed and has no settings on it. The unit then has a bunch of tuning settings that can be modified.

Ok so if you call them and buy the programmer module aswell (a further 295) you can adjust the settings they originally the are from essing performance you could try them aswell. The wire in to the pump on the top most wire closest to the guard from the control module on top of the pump to the...

Ok so i finally purchased one a week and a bit ago and installed it last friday. After a little bit of playing around with the settings i have settled on a tune that im pretty happy to run with. Doesnt blow much smoke if any and pulls like a truck. of course this was just my feeling at the...

A Friend of mine has just started a suspension and accessories for 4x4s business and is offering 20% off retail prices for the month of November as a sort of opening/Christmas special the coupon code is GIVEME20 and once you add that in the cart you will receive 20% off any suspension component...

Its the seal for the lid of the airbox. Mine was the same and yeah fixed with a bit of foam from clarky's.

Sounds like your on the way to needing a gvm upgrade if your that heavy with that ammount of gear in it all the time let alone when you want to go camping and have it really loaded.

Either these http://www.eachbuyer.com/10-t10-w5w-168-194-bright-white-9-smd-led-side-wedge-light-bulb-lamp-p33551.html Or thesehttp://www.eachbuyer.com/2pcs-5w-t10-cree-q5-8-smd-2323-white-auto-car-led-light-lamp-bulb-p182760.html The type with the lens on top are so freaking bright but get a...

It's awesome that you have shown which products that you use to complete each job, how about add on approximate minimum cable lengths to help out people that are unsure when buying the bits for the job. This may be a hard task as it will somewhat vary in different models and locations that you...

People with out turbo upgrades have had around 130Hp at the wheels out of a tuned ZD30 D22 with a turbo upgrade probably a bit more but depending on what the chip would allow. Also for a turbo upgrade would you consider one of these...