Recent content by thewanderer

The hub will need to be removed to have room to slide the new stud in... Done it a couple of times now..

12 months ago a diff place had the rear diff apart to shim it up, turned out the centre was that flogged out it wasn't repairable... The elocker was cheaper than a new LSD so I went for the rear first ( obvious reasons) a mint or so ago I snapped a pinion shaft in the front diff so figured I'd...

Well I've been slack and found more exciting things to do,,, like drive the ute , then I broke the front diff so I had a locker put in the replacement before I fitted the diff.., and then I drove it some more.,, new dump pipe and a few other bit and few more camp trips , which means the tray Is...

Are there instructions for the fitting of the chip??? If so are you negotiable on price??? Cheers

How are the wearing??? Getting many k's on them??

I now have a diff that I can part out if needed.... I snapped a pinion shaft in the front last weekend .,, it's a standard diff from an 05 3ltr

Just wondering if anybody can give me a rough price on the replacement body mounts,,,, Cheers

What did they set you back if you don't mind me asking john,,,

I'm keen to kno aswell for a single cab

Cheers mate ... Have replied to your message,.

I haven't done a body lift but it's on the list to do ., , my front body mount is rooted and letting the cab bounce around and I was thinking that I would need to find a new mount to put in at the same time as the lift blocks... Would that be the right process??

Hi... I've seen this pop up a few times now.,, Just wondering if you would take $140 posted ??? Cheers...

Hopefully you might get away with just replacing the pressure washer and a spacer or something.,, I didn't have that luxury as I had put up with it slipping for too long and the hemispheres were chopped out from the Clutch plates knocking back and forth,,,

Hi mate.., not sure on the price of the clutch plates at stuff as I was in need of a complete LSD centre when my diff went but the mechanic did the research and found that it was $100 or so cheaper to put an e-locker in the back compared to a new LSD centre from Nissan.,,

You could get some 3" rhs and drill thru the whole lot so that the tool box pulls up tight to the front.,,, does that make sence??