I have been using Magnetec diesel for last 60k... done 120k and all good..
Runs smooth until about 6k (from last change) then gets a little noisy
Always warm up and warm down for a good minute, more if towing/etc
No problems....
4x4 STR if it is mild steel it will have a yield stress (sigma) of 250MPa. Stress = Force / Area with force in Neutons (kg x 9.1) and area in sqm. Look up basic engineering mechanics (statics) and obtain a copy of AS4100 Steel structures and all will be revealed ;)
Hi all,
Looking at a lift kit (duh)...
Anyone in QLD installed this? http://www.purenissan.com/3_suspension_4wd.htm
Mod plate required as it is greater than 2"?!?
What about the rear springs.. whats the go? What do I replace the standard ones with.
Also, CV angle.. anyone got this installed...
Hi all, I have obtained an airbox... Its 310mm dia and looks like it will be a tight fit. Is this figure the same as what everyone else has been using? Cheers.
Hello fellow Navarians,
The black beast has been given it's TLC and is ready for a good ole fashioned work out over the christmas break.
So I'm looking at doing a trip over new years/first week of January somewhere in the north-east of NSW.
I've done Double Island Point, Bribie Island, and...
My mate just put a safari one on his d22...
For his install he had to re-locate the side indicator. I noticed it sounds a bit 'farty' at idle
I got the genuine nissan one.. little bit farty but not as noticable i think.. but its louder like more sucking noise than 'farty' noise..
.. or maybe...
Well I fixed it tonight...
Behind the battery on the driverside engine bay is the supply line coming from the tank. Found a 3m length of pressure hose lying around that fitted perfect (3/8?).
Put on the length of hose, let the fuel rail drain out, then breathed about 3-4 times to pressurise...