Out of interest, how many of you havent done the EGR block mod and would be keen to do it??? Have a sheet of stainless at home that i can make the plates with at work. Only reason I havent done mine yet is effort lasyness and time, so would be good, could cut up a heap of them on the saturday. We knock off at 11 so anytime after that will be fine to arrive.
Just for house keeping;
- I dont expect all of you to own steel cap boots but please at least covered in shoes.
- If you plan to do some welding some jeans and a flanny or long sleeve shirt to throw on while welding (although i expect this first day to be a bit more of a meet and greet, setup and planning)
- Fridges are also on site to store food and beverage of all varieties.
- We have a full functioning paint booth and guns good enough to do most rough jobs, for any body panel (good finish) type stuff I would suggest borrowing or sourcing a decent gravity feed gun.
- Please bring axel stands if you plan on getting under your cars
- Oil Drain pans if you plan on doing services, i have facilities for getting rid of waste oil
- Any tools ie, spanners and sockets you may think you will need, I will have a my personal spanners and sockets available for use but our shop has limited resources on that front although we do have 1/2" drive rattle guns available.
Please be aware that this is manufacturing workshop and can be a dangerous place, that said I am very easy going as long as a bit of commence is displayed and employed and a quick informal induction on the day there shouldnt be any problems.
I think we are onto a good thing and look forward to meeting a few more of you.
Look foward to meeting you guys.